Interior Fit Out of Baseboards

Sometimes when homes are undergoing a change such as changing the look or expanding the space it is better to hire the services of a professional contractor. The change may be for making space for an addition to the family or simply to give a new looking to the home. The work done on the house should be precise and professional so that no problems are seen. Interior fit out of homes may refer to numerous different factors such as ceiling, lighting, insulation, windows, doors, baseboards and much Office fit out company more. Some people just go for small and minor changes while others go for a complete remodeling of their homes. Baseboards are an essential feature that needs to be considered while thinking of remodeling the house.

Starting the Installation of Baseboards

When starting the installations of the baseboards in the homes it is best to start with the longest wall. Taking the example of a bedroom the best place to start is with the longest wall in the room and it is best to do one piece at a time. Once people get the hang of how to go about they can take several measurements at the same time. Take the measure and tape and carefully get the precise measurement from each corner to corner of the sheetrock. The best way to go is to choose a good piece of baseboard trim and few more wood colored and grain patterned pieces. The pieces should match to the best ability in order to ensure a good quality of baseboard interior fit out.

Using the Miter Saw

If there is any unwanted piece or the new baseboard trim they need to be placed on the miter saw with the back against the fence and the finished front facing outward. In order to gain total control of the baseboard against the fence of the miter saw the table or the surface needs to be firmly secured. To avoid inflicting injury to you and also to ensure a neat outcome of the work it is better to get a good handle on the wood while cutting it. It is ideal to cut 3″ to 4″ length few pieces to use. For the new piece of wood set it on the miter saw and cut off the end to get a good square end. The next step is to transfer the measurements taken earlier from the bedroom onto this piece of baseboard and keep another 1/8″ at hand. These step by step processes ensure an easy interior fit out of baseboards in homes.

Sometimes there are a few stud locations that need to be taken care of and shooting with a nail gun is the best way to go about. The stud location can be found by the mark on the floor and once it is determined measure it with the tape and mark every 16″ with a pencil in both sides towards the corners. The studs are usually 16″ on the center however sometimes the studs may be 2″on the center and this is standard with lower level.

 

You may also like

Leave a Reply

Your email address will not be published. Required fields are marked *